IRRIGATION SYSTEM INFORMATION
UPDATED 06-10-2019

INDEX OF CONTENTS

  • Well Pump Info
  • Irrigation Manuals
  • Irrigation Zones & Settings
  • Irrigation Rotor and Spray Head Mapping


  • The following information will assist in the administration and operation of the Homeowners Association irrigation system:

    Well Pump Info - Installed May, 2012

  • Well Pump Bill (.pdf - opens in a new page)

  • Hunter PRO-C PCC-600 Irrigation Controller - Installed June 10, 2019

  • Hunter PCC_600 Controller Quick Start How To (.pdf - opens in a new page)
  • Hunter PCC-600 Controller Instructions (.pdf - opens in a new page)
  • Controller requires: 1) CR2032 Battery; 2) 9V Alkaline Battery

  • Irrigation Zones & Settings Revised 7-04-2018

    Unincorporated Hillsborough County Watering Schedule - use link on home page -
    See current Hillsborough County Watering Restrictions for Times and Days Private Well Irrigation may be used

    RUN DAYS:
    ......Wed and Sat (per county regulations for common areas)
    START TIME:
    ......"A" Program @ 12:30AM -- set to current watering days
    SEASONAL ADJUSTMENT % ......Seasonal Adjustment = 100% Summer / 85% Winter
  • ......Zone 1 = 105 minutes Summer / 89 minutes Winter (Center Island Grass - Rotors)
  • ......Zone 2 = 45 minutes Summer / 38 minutes Winter (West Beds - Spray Nozzles)
  • ......Zone 3 = 45 minutes Summer / 38 minutes Winter (East Grass - Rotors)
  • ......Zone 4 = 45 minutes Summer / 38 minutes Winter (West Grass - Rotors)
  • ......Zone 5 = 45 minutes Summer / 38 minutes Winter (Entrance Island & East Beds - Spray Nozzles)
  • ......Zone 6 = ZERO minutes (can be used for faucet - SEE CAUTION BELOW)


  • "B" Program - used ONLY to provide water to the hose bib for Manual Watering / Pressure Washing only
  • ......Start Time can be any setting
  • ......"On" Day = any day
  • ......Zone 1 thru 5 = ZERO minutes
  • ......Zone 6 = ZERO minutes - open faucet then set to > 0 for faucet / return to 0 when done and close faucet - SEE CAUTION BELOW)


  • "C" Program - not used

    Rain Sensor - Hunter Micro-Clik
  • ......Installed June, 2015
  • ......Set to 1/2"

  • Battery (backup)
  • ......Replaced June, 2015 / August 2018 / April 2019
  • ......CR2032

  • CAUTION FOR IRRIGATION SYSTEM / WELL PUMP
    The 3hp well pump produces 50 gallons of water per minute. Pressure can reach over 100 psi if output is restricted -- this pressure is sufficient to burst pvc pipes, garden hoses and can also ruin the pump if the water does not have an open outlet.
    The hose spigot is charged with water everytime the pump runs - for every zone - as it is attached directly to the pump outgoing water line.
    When the system is operating (Zones 1 thru 5) the hose spigot must be turned OFF to allow sufficent pressure to run the sprinklers
    Under No Circumstances should the pump be run without the hose spigot open or a zone operating
    NEVER RUN THE PUMP WITH JUST ZONE 6 WITH THE HOSE SPIGOT CLOSED OR DAMAGE WILL OCCUR ZONE 6 AND THE HOSE SPIGOT CAN BE USED FOR PRESSURE WASHING - ATTACH A "T" AND THERE IS A HOSE THAT RUNS UNDER THE FENCE TO PERMIT DUMPING WATER FROM ONE SIDE OF THE "T"

    Watering Within 24 Hours After Lawn Chemicals and Fertilization
  • If watering is needed -- starting after 6PM - if not the day before watering - simply turn controller knob to MANUAL START and then to RUN / or push the ">" button for 2 seconds
  • Dated signs must be displayed
  • Do not turn sprinklers on the evening before overnight watering is to start


  • SYSTEM PRESSURE MONITORING
  • ......Zone 1 Center Island Grass @ 55 LBS
  • ......Zone 2 West Side Bed (fence to sidewalk) @ 50 LBS
  • ......Zone 3 East Side Grass (road to sidewalk) @ 82 LBS
  • ......Zone 4 West Side Grass (road to sidewalk) @ 70 LBS
  • ......Zone 5 @ 55 LBS
  • ......Zone 6 N/A. Note Set to 0 minutes - NOTHING CONNECTED - ONLY USE WITH FAUCET OPEN OR IT WILL OVERPRESSURIZE THE SYSTEM



  • Irrigation System Head Mapping - 9-22-2015

  • Irrigation System Head Mapping Adobe .pdf
  • Irrigation System Head Mapping EXCEL